|
|
Klixon Phenolic Motor Protectors |
– |
|
Single–phase: |
|
|
|
|
|
|
– |
|
Three–phase: |
|
|
|
|
|
|
|
|
|
– |
|
|
|
|
|
|
Industrial motors |
|
Agricultural equipment |
|
Well and sump pumps |
|
Fans |
|
Air conditioners |
|
Refrigerators |
|
Home appliances |
|
...And more! |
|
|
|
|
|
|
Sensata > Products > Klixon Brand > Motor Controls >
Klixon® phenolic motor protectors
AC off–winding non–hermetic single–phase
Features and Overview |
/\ Top |
|
|
Snap–action Klixon bimetal disc |
|
Sensitive to both temperature and current |
|
Precision calibration |
|
Protects ½ to 5 HP motors |
|
Normally closed |
|
Automatic or manual reset |
|
Fractional to 10hp |
|
Easy to install |
|
UL recognized, CSA certified, VDE certificate |
|
|
|
|
|
CODE: Phenolics
|
|
Sensata Technologies’s line of automatic and manual reset protectors phenolic protectors are intended for ½ hp to 15 hp general purpose, commercial and industrial motors. These single–phase and three–phase protectors can be used in single and dual voltage type motors.
Overheating of motor insulation causes a reduction in dielectric strength. This can result in motor insulation damage or failure.
Klixon phenolic motor protectors are equipped with a bimetallic snap–acting disc, on which the contacts are mounted, and through which the current flows. If overheating conditions occur, the heating effect of the current flow through the Klixon disc and the influence of motor heat will cause the disc temperature to rise.
When the disc reaches the calibrated setpoint, the Klixon protector automatically opens and shuts down the motor, limiting the winding and shell temperature.
When the motor has cooled to an acceptable operating level — allowing the protector to cool to its reset temperature — the Klixon protector resets automatically to a closed contact position. This allows the motor to restart.
This chart is used to determine protector size needed when making an application. For reference only.
|
Maximum Recommended Contact Rating |
/\ Top |
|
This chart is used to determine the protector size needed when making an application. To be used for reference only. |
Size |
Disc Contacts |
Terminals |
Maximum Current V=120 |
Maximum Current V=240 |
0.75" |
High capacity |
Low capacity |
32 |
25 |
0.75" |
High capacity |
High capacity |
50 |
37 |
1.00" |
Low capacity |
Low capacity |
40 |
30 |
1.00" |
High capacity |
Low capacity |
40 |
30 |
1.00" |
Low capacity |
High capacity |
40 |
30 |
1.00" |
High capacity |
High capacity |
80 |
60 |
1.25" |
Standard |
Standard |
135 |
100 |
1.50" |
Standard |
Standard |
175 |
130 |
|